Festool 205222 AN-UNI Centrotec FastFix Right Angle Chuck
Switch between drill functions in seconds with the FastFix interface saving time and eliminating cost of dedicated single purpose tools. The Festool FastFix Right Angle Chuck is the ultimate solution for close quarters hole or fastener placement. Drill or drive between studs joists cabinet or drawer spaces or virtually any constrained space without switching over to a separate dedicated tool. 1/4 inch hex drive with wire detent. Accepts Festool Centrotec or adjustable 1/2 inch chuck. Chuck rotates 360 degrees without the need to remove it. Works with all existing and previous model Festool drills equipped with FastFix interface for toolless change of chucks.
Quick rotation using the green adjustment ring
Allows you to drive screws or drill holes in extremely tight or hard to reach spaces without the need for dedicated tools
Accepts Festool Centrotec or adjustable 1/2 inch chuck. Chuck rotates 360 degrees without the need to remove it from the drill.
Switch between drill functions in seconds with the FastFix interface saving time and eliminating cost of dedicated single purpose tools
Getting it right the first time eliminates waste of material and fasteners and saves valuable time
Not compatible with Festool CXS or TXS drill models.
Festool CompatibilityC 12 C 15 C 18 T 12 T 15 T 18
Minimum Bit Diameter1/4"
Maximum Bit Diameter1/4"
Product TypeDrill Accessory
Specifications
Accepts Festool Centrotec or adjustable 1/2 inch chuck. Chuck rotates 360 degrees with 16 presets.
(1) Festool 205222 AN-UNI Centrotec FastFix Right Angle Chuck
