Replacement zero-clearance anti-splinter edge
Specifications
Length -- 197"
Warranty Specifications
- 90 Day Money Back Guarantee
- 1 Year Free Service Contract
- 3 Year Limited Warranty
Replacing the Strip
Remove the existing strip using a blunt scraper and appropriate acetone or organic based solvent. When existing strip and adhesive are completely removed and the surface is clean and dry the new strip can be applied. Be careful not to stretch the strip as it is applied. Force should be applied to strip when it is in position to make certain the two surfaces have bonded uniformly and no air gaps are present. The track can now be used immediately.
IMPORTANT: ALWAYS read and follow the guide system instructions before cutting with the Anti-Splinter Strip for the first time!
- Place the track on a scrap piece of wood.
- Set the track saw to 3/16 (5mm) cut depth.
- Set TrackSaw to maximum speed.
- Place the saw on the rear end of the guide track.
- Turn the saw on, plunge TrackSaw set cutting depth and cut the Anti-Splinter Strip along the full length in one continuous operation.
