Switch between drill functions in seconds with the FastFix interface saving time and eliminating cost of dedicated single purpose tools. The Festool FastFix Offset Chuck places bits flush to side enabling close-quarters drilling and driving so you can place holes and fasteners near-perfectly adjacent to walls and into corners. Significantly faster and easier than the alternative of driving screws in tight spaces manually. Chuck rotates 360 degrees without the need to remove it from the drill. Quick-release collar will not mar adjoining surfaces. Switch between drill functions in seconds with the FastFix interface saving time and eliminating cost of dedicated single use tools. Getting the job done right the first time eliminates waste of material and fasteners and saves valuable time. Works with all existing and previous model Festool drills equipped with FastFix interface for toolless change of chucks.
Quickly adjust and rotate the chuck without the need to remove it from the drill using the green ring
Enables close-quarters drilling and driving allowing you to get holes and fasteners near-perfectly adjacent to walls and into corners
Switch between drill functions in seconds with the FastFix interface saving time and eliminating cost of dedicated single use tools
Getting it right the first time eliminates waste of material and fasteners and saves valuable time
Significantly faster and easier than the alternative of driving screws in tight spaces manually
NOTE: This chuck is not compatible with the Festool PDC 18 hammer drill CXS models or TXS models.
Festool CompatibilityC 12 C 15 C 18 T 12 T 15 T 18
